Download New Updated (July) CompTIA SG0-001 Actual Test 221-230

Ensurepass

 

QUESTION 221

Which of the following combinations are valid?

 

A.

A SAS Drive can connect to a SATA Backplane

B.

A SATA Drive can connect to a SAS Controller

C.

A SAS Drive can connect to a SATA Controller

D.

A SATA drive can connect to a FC expander

 

Correct Answer: B

 

 

QUESTION 222

SAN zoning provides which of the following?

 

A.

A means to mask LUNs for clients

B.

A method with which to divide the fabric into VSANs

C.

A means of partitioning a SAN fabric at the network layer

D.

A means of controlling access to storage at layer 4

 

Correct Answer: C

 

 

QUESTION 223

Data STaaS refers to which of the following?

 

A.

Remote storage purchased from a third party on a subscription basis

B.

Setting up a server to run a storage service such as iSCSI or NFS

C.

Setting up a client to run over Ethernet or SAN storage

D.

Service contracts provided by SAN vendors for immediate replacement of faulty hardware

 

Correct Answer: A

 

 

QUESTION 224

A customer requests that a new SAN enclosure be installed on the top slots of an unused rack. Which of the following is a reason why a technician might deny this request?

 

A.

Improper airflow from the HVAC is caused by this installation enclosure.

B.

The rack’s stability is threatened by the installation enclosure.

C.

Raised floor power comes from below in this installation.

D.

Cable management will be difficult in this setup.

 

Correct Answer: B

 

 

QUESTION 225

Which of the following disk drives is MOST common in a SAN?

 

A.

IPI

B.

EIDE

C.

FC

D.

IDE

 

Correct Answer: C

 

 

QUESTION 226

Which of the following is a benefit of tiered storage?

 

A.

Lowers cost over time

B.

Provides redundancy to all clients

C.

Increases physical security

D.

Enables disaster recovery

 

Correct Answer: A

 

 

QUESTION 227

Which of the following maybe a contributing factor to a higher than average disk failure rate?

 

A.

High cache hit ratio

B.

Inadequate cooling

C.

Non-redundant power

D.

Improper RAID level

 

Correct Answer: B

 

 

QUESTION 228

The ports for a server and storage system are registered with the fabric’s name server yet cannot communicate with each other. Which of the following is the MOST likely cause of the issue?

 

A.

Failed storage system port

B.

Jumbo frames are not supported

C.

Zoning misconfiguration

D.

Incorrect VLAN

 

Correct Answer: C

 

 

QUESTION 229

Which of the following are Ethernet based protocols? (Select TWO).

 

A.

iSCSI

B.

SAS

C.

FCoE

D.

FC

E.

SATA

 

Correct Answer: AC

 

 

 

QUESTION 230

A server has two HBAs each connected to redundant fabrics. The fabrics have multiple connections to the storage targets. Which of the following is true?

 

A.

Multipathing will not work in this configuration

B.

Multipathing will not be needed in this configuration

C.

Multipathing will provide high availability

D.

Each HBA is a single point of failure

 

Correct Answer: C

 

Free VCE & PDF File for CompTIA SG0-001 Real Exam

Instant Access to Free VCE Files: CompTIA | VMware | SAP …
Instant Access to Free PDF Files: CompTIA | VMware | SAP …

This entry was posted in SG0-001 Real Tests (July) and tagged , , , , , , . Bookmark the permalink.