[Free] 2017(Sep) EnsurePass Passguide Cisco 210-065 Dumps with VCE and PDF 101-110

Ensurepass.com : Ensure you pass the IT Exams
2017 Sep Cisco Official New Released 210-065
100% Free Download! 100% Pass Guaranteed!

Implementing Cisco Video Network Devices v1.0

Question No: 101 – (Topic 5)

An engineer is consistently seeing tickets in the Cisco TMS that are generated when a video endpoint is powered off each day. Which menu path allows the engineer to prevent this type of ticket from being created?

  1. TMS gt; Clear this ticket

  2. TMS gt; Acknowledge ticket

  3. TMS gt; Ignore ticket type for this system

  4. TMS gt; Ticket management

  5. TMS gt; Manage ticket error levels

Answer: C

Question No: 102 – (Topic 5)

Refer to the exhibit.

Ensurepass 2017 PDF and VCE

Management would like to find out when a particular multipoint control unit feature was enabled and who enabled it. Which menu option is the most appropriate when searching for that information?

  1. Event Display Filter

  2. Audit Log

  3. Event Log

  4. Syslog

Answer: B

Question No: 103 – (Topic 5)

Refer to the exhibit.

Ensurepass 2017 PDF and VCE

Under which tab can the registration status for the endpoint be found?

  1. Diagnostics

  2. Configuration

  3. Call Control

  4. Maintenance

Answer: A

Question No: 104 – (Topic 5)

What is the importance of defining option 150 in the DHCP server for Cisco TelePresence endpoints?

  1. Option 150 is not important.

  2. It is the TFTP server IPv4 address where the video endpoint retrieves its configuration file while booting.

  3. It is the IPv4 address of the default gateway for the subnet that the video endpoint is connected to.

  4. It is the configured SIP registrar and proxy server.

  5. It is the unique NTP server IPv4 address.

Answer: B

Question No: 105 – (Topic 5)

The microphone on a Cisco TelePresence System 3000 is switching incorrectly to a camera that does not have an active speaker. What is the first step that an engineer should take to troubleshoot this issue?

  1. Check whether the microphone is properly plugged in.

  2. Run the microphone calibration procedure.

  3. Plug all microphones into the primary codec.

  4. Check whether the cable from the microphone is plugged into the correct receptor on the codec.

Answer: B

Question No: 106 – (Topic 5)

A Cisco TelePresence EX Series desktop endpoint failed to register to a Cisco VCS. The SIP status shows quot;Failed: 403 Forbiddenquot; in the endpoint#39;s web interface. What is the first thing that should be checked in the endpoint configuration settings?

  1. Verify that the correct SIP authentication credentials have been configured.

  2. Ensure that CallSetup Mode is set to Gatekeeper.

  3. Verify that Outbound Connection Credentials are properly configured.

  4. Check to see that SIP Mode is set to On.

Answer: A

Question No: 107 – (Topic 5)

A Cisco engineer needs to provide digital media for the lobby of a company. Which Cisco Digital Media component should the engineer use?

  1. Cisco Cast

  2. Cisco Digital Signs

  3. Cisco DMP

  4. Cisco Show and Share

  5. Cisco IP TV

Answer: B

Question No: 108 – (Topic 5)

A company acquired immersive Cisco TelePresence devices and they are setting them up in a dedicated Cisco TelePresence room. Which two options are recommendations for the lighting of the room? (Choose two.)

  1. direct lighting

  2. lighting of 5000K to 5100K

  3. color rendering index of 82 and above

  4. lighting of 4000K to 4100K

  5. facial lighting between 400 to 600 lux

Answer: C,D

Question No: 109 – (Topic 5)

Which two of these are required in order to complete the password recovery of a Cisco TelePresence System endpoint? (Choose two.)

  1. must have FTP enabled on the endpoint

  2. must have SSH enabled on the endpoint

  3. must have the security question answer for the endpoint

  4. must be in the same room as the main display

  5. must have SFTP enabled on the endpoint

  6. must call Cisco TAC for the security code

Answer: B,D

Question No: 110 – (Topic 5)

A network administrator is asked to configure a video conference using the Cisco TelePresence MCU 5300. There is a requirement for participants to start with the same layout when joining the conference. How can this goal be accomplished?

  1. Layouts cannot be customized on the MCU 5300.

  2. Configure a custom layout for each user individually.

  3. Configure a custom layout and apply the layout to all new participants.

  4. Allow each endpoint to configure its own layout.

Answer: C

100% Ensurepass Free Download!
Download Free Demo:210-065 Demo PDF
100% Ensurepass Free Guaranteed!
Download 2017 EnsurePass 210-065 Dumps

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

2017 EnsurePass IT Certification PDF and VCE

This entry was posted in 210-065 Latest Exam (Sep 2017) and tagged , , , , , , , , , , , , , , . Bookmark the permalink.

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.