[Free] 2017(Sep) EnsurePass Passguide Cisco 210-065 Dumps with VCE and PDF 151-160

Ensurepass.com : Ensure you pass the IT Exams
2017 Sep Cisco Official New Released 210-065
100% Free Download! 100% Pass Guaranteed!
http://www.EnsurePass.com/210-065.html

Implementing Cisco Video Network Devices v1.0

Question No: 151 – (Topic 5)

A Cisco TelePresence System 1300 Series endpoint is in the process of booting and the engineer notices a red quot;Xquot; on the screen for Step 6 in the boot process. What does this red quot;Xquot; indicate?

  1. The endpoint failed to load its firmware.

  2. There is an error with compact flash.

  3. The endpoint could not obtain an IP address via DHCP.

  4. The touch panel is malfunctioning.

Answer: B

Question No: 152 – (Topic 5)

Which two of these are considered to be provisioning and scheduling management tools in a Cisco TelePresence environment? (Choose two.)

  1. Cisco TelePresence Manager

  2. Cisco Video Surveillance Operations Manager

  3. Cisco TelePresence Management Suite

  4. Cisco TelePresence Multipoint Control Unit

  5. Cisco Video Surveillance Management Server

Answer: A,C

Question No: 153 – (Topic 5)

Which Cisco Video Surveillance product contains the Cisco Video Surveillance Encoding Server?

  1. Video Communications Server

  2. Cisco Video Surveillance Operations Manager

  3. Cisco Video Surveillance Media Server

  4. Cisco Video Surveillance Transcoding and Encoding Server

  5. Cisco Video Surveillance Virtual Matrix

Answer: B

Question No: 154 – (Topic 5)

An engineer wants to know if there is a way to determine the optical zoom of a Cisco TelePresence SX20 remotely. Which two methods will retrieve this information? (Choose two.)

  1. From the CLI, run xstatus.

  2. From the CLI, run xconfig.

  3. From the web GUI, choose Configuration gt; System Status gt; Camera.

  4. From the web GUI, choose Configurationgt; Camera gt; Status.

  5. From CLI, run xcommand camera.

Answer: A,C

Question No: 155 – (Topic 5)

An engineer must pull logs from an Cisco EX90 Codec for a Call setup issue. The engineer opens a Telnet session to the codec and enters the log ctx SipPacket debug 9 command. The engineer places a test call, but sees no debugs on the console. Which action must the engineer take to review the logs?

  1. SSH into the codec to view the logs

  2. Enter the log ctx SipPacket debug all command

  3. Enter the log output on command.

  4. Collect logs from the web interface.

Answer: C

Question No: 156 – (Topic 5)

Refer to the exhibit.

Ensurepass 2017 PDF and VCE

What can be deduced from the log shown in the exhibit, which was taken from a Cisco TelePresence Codec C60?

  1. A direct call to 52902511 is being made.

  2. A Multiway call to multiway221@osl147.local is being made.

  3. No calls are being attempted by the endpoint.

  4. A BFCP call is being initiated.

  5. The endpoint is receiving a call from the VCS.

Answer: B

Question No: 157 – (Topic 5)

Refer to the exhibit.

Ensurepass 2017 PDF and VCE

In the SDP that is displayed, to which IP address and port should the receiving end send its content video channel media?

A. 192.168.1.4:2048

B. 192.168.1.4:50000

C. 192.168.1.5:50002

D. 192.168.1.5:50008

Answer: D

Question No: 158 – (Topic 5)

An engineer needs to configure cascading to support additional video conference attendees. What are two capabilities when cascading? (Choose two.)

  1. Conductor automatically performs cascading.

  2. A maximum of four multipoint control units are supported.

  3. Cascading is supported for the Cisco TelePresence Server in remotely managed mode.

  4. Cascading is supported for multipoint control units that are registered to Cisco Unified Communications Manager.

  5. All cascaded multipoint control units must be in the same location.

Answer: A,C

Question No: 159 – (Topic 5)

Which two methods are used to navigate the menu options of an auto attendant on an MCU? (Choose two.)

  1. KPML

  2. DTMF

  3. PiP

  4. PoP

  5. FECC

  6. SCCP

Answer: B,E

Question No: 160 – (Topic 5)

An immersive video room requires acoustic remediation because there is noticeable reverb present. What type of acoustic paneling does Cisco recommend to provide remediation?

  1. NRC rating greater than 0.75

  2. NRC rating greater than 0.5

  3. NRC rating less than 0.75

  4. NRC rating less than 0.5

Answer: A

100% Ensurepass Free Download!
Download Free Demo:210-065 Demo PDF
100% Ensurepass Free Guaranteed!
Download 2017 EnsurePass 210-065 Dumps

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

2017 EnsurePass IT Certification PDF and VCE

This entry was posted in 210-065 Latest Exam (Sep 2017) and tagged , , , , , , , , , , , , , , . Bookmark the permalink.

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.