[Free] 2017(Sep) EnsurePass Passguide Cisco 210-065 Dumps with VCE and PDF 51-60

Ensurepass.com : Ensure you pass the IT Exams
2017 Sep Cisco Official New Released 210-065
100% Free Download! 100% Pass Guaranteed!
http://www.EnsurePass.com/210-065.html

Implementing Cisco Video Network Devices v1.0

Question No: 51 – (Topic 3)

Refer to the exhibit.

Ensurepass 2017 PDF and VCE

Users in a Cisco TelePresence room report audio and video quality issues. You have been asked to troubleshoot the issue. You log in to the endpoint GUI and check telephony settings. Which option would you recommend to resolve the issue?

  1. Audio/video quality issues are generally due to low bandwidth. Contact your carrier to increase the bandwidth.

  2. quot;DSCP For TelePresencequot; is not correct. Configure the correct value via codec GUI.

  3. quot;DSCP For Audioquot; is not correct. Configure the correct value via codec GUI.

  4. DSCP values are correct. Check the QoS configuration on the router.

  5. The quot;DSCP For TelePresencequot; and quot;DSCP For Audioquot; values are not correct. Configure the correct value in codec GUI.

  6. The quot;DSCP For TelePresencequot; and quot;DSCP For Audioquot; values are not correct. Configure the correct value in the Cisco Unified Communications Manager service parameter.

Answer: F

Question No: 52 – (Topic 3)

Refer to the exhibit.

Ensurepass 2017 PDF and VCE

When the administrator clicks the ticket number of any of the open tickets, which two actions are presented to the administrator? (Choose two.)

  1. ignore ticket

  2. acknowledge ticket

  3. delete ticket

  4. close ticket

  5. escalate ticket

Answer: A,B

Question No: 53 – (Topic 3)

Which two of these are required in order to complete the password recovery of a Cisco TelePresence System endpoint? (Choose two.)

  1. must have FTP enabled on the endpoint

  2. must have SSH enabled on the endpoint

  3. must have the security question answer for the endpoint

  4. must be in the same room as the main display

  5. must have SFTP enabled on the endpoint

  6. must call Cisco TAC for the security code

Answer: B,D

Question No: 54 – (Topic 3)

Your customer has an EX60 at a home-office that is doing direct H.323 dialing. When they place calls to remote sites, they report that they cannot see video or hear audio from the remote sites. What is most likely the cause of this issue?

  1. NAT mode is not configured on the EX60.

  2. The HDMI cable that connects the EX60 to the monitor is not plugged in.

  3. A username and password must be configured on the EX60.

  4. QoS is not properly configured on the EX60.

Answer: A

Question No: 55 – (Topic 3)

Refer to the exhibit.

Ensurepass 2017 PDF and VCE

Which option enables you to create a system snapshot?

  1. Status

  2. System

  3. Configuration

  4. Applications

  5. Users

  6. Maintenance

Answer: F

Question No: 56 – (Topic 3)

Refer to the exhibit.

Ensurepass 2017 PDF and VCE

When this alarm is seen, what is the maximum number of registrations that a Cisco VCS can support?

A. 2500

  1. 50

  2. 3

  3. 0

Answer: C

Question No: 57 – (Topic 3)

Your customer reports that they have had unwanted calls routing from their Cisco VCS Expressway to their ISDN gateway. Which way is recommended to prevent these calls?

  1. Configure a Registration Deny List on the Cisco VCS Expressway.

  2. Configure a Registration Allow List on the Cisco VCS Expressway.

  3. Implement a CPL on the Cisco VCS Control.

  4. Implement a CPL on the Cisco VCS Expressway.

Answer: D

Question No: 58 – (Topic 3)

A technician has installed and powered on a Cisco TelePresence MCU 5320 and is connected via the console port. The technician needs to determine the IP settings that were automatically assigned via DHCP. Which command should be entered?

  1. xstatus

  2. show network eth0

  3. status

  4. help static

Answer: C

Question No: 59 – (Topic 3)

A technician is trying to pair a Touch 8 with a Cisco TelePresence SX20 endpoint, but the codec is not automatically listed in the touch panel. What are two possible reasons for this behavior? (Choose two.)

  1. The codec firmware version is below version TC 6.1.

  2. The codec and the Touch 8 are on separate subnets.

  3. Pairing visibility mode is not active on the codec.

  4. The codec is not compatible with a Touch 8 device.

  5. The Touch 8 is connected via the second Ethernet port on the codec.

Answer: B,C

Question No: 60 – (Topic 3)

Which command causes a Cisco VCS to drop registrations for currently registered endpoints only if they are not currently in a call?

  1. xConfiguration SystemUnit Maintenance Mode: Off

  2. xConfiguration SystemUnit Maintenance Mode: On

  3. xConfiguration Zones LocalZone DefaultSubZone Registrations: quot;Denyquot;

  4. xConfiguration Registration RestrictionPolicy Mode: quot;DenyListquot;

Answer: B

100% Ensurepass Free Download!
Download Free Demo:210-065 Demo PDF
100% Ensurepass Free Guaranteed!
Download 2017 EnsurePass 210-065 Dumps

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

2017 EnsurePass IT Certification PDF and VCE

This entry was posted in 210-065 Latest Exam (Sep 2017) and tagged , , , , , , , , , , , , , , . Bookmark the permalink.

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.