[Free] 2018(Jan) EnsurePass Dumpsleader Juniper JN0-343 Dumps with VCE and PDF 211-220

Ensurepass.com : Ensure you pass the IT Exams
2018 Jan Juniper Official New Released JN0-343
100% Free Download! 100% Pass Guaranteed!
http://www.EnsurePass.com/JN0-343.html

Juniper Networks Certified Internet Specialist (JNCIS-ENT)

Question No: 211 – (Topic 3)

Router R2 is having adjacency problems with Router R1. Router R2 is stuck in ExStart state.

What is causing the problem?

  1. There is a physical and data link layer problem between R1 and R2.

  2. There is a misconfigured IP address on the R2 interface.

  3. The hello and dead intervals on R2 do not match R1.

  4. The interface MTU setting on R2 does not match R1.

Answer: D

Question No: 212 – (Topic 3)

Ensurepass 2018 PDF and VCE

In the exhibit, six routers (R1, R2, R3, R4, R5, and R6) are attached to a single Ethernet

LAN and configured with addresses in the same subnet. All devices boot at the same time. Which router will become the designated router (DR), and which router will become the backup designated router (BDR)?

  1. DR:R3 BDR: R4

  2. DR: R4 BDR: R3

  3. DR: R6 BDR: R1

  4. DR: R6 BDR: R2

Answer: D

Question No: 213 – (Topic 3)

N NO: 212

You attach six routers (R1, R2, R3, R4, R5, and R6) to a single Ethernet LAN and configure the routers with addresses in the same subnet. You do not modify the default priority of any router. R1 is chosen as the designated router and R2 is chosen as the backup designated router. How many full adjacencies does R3 have?

  1. 0

  2. 1

  3. 2

  4. 5

Answer: C

Question No: 214 – (Topic 3)

You want to allow RIP routes to be redistributed by an ASBR into the connected OSPF area, but you do not want to recieve external routes from other OSPF areas.

Which OSPF area type would be used to satisfy the requirement?

  1. transit area

  2. stub area

  3. totally stubby area

  4. not-so-stubby area

Answer: D

Question No: 215 – (Topic 3)

Ensurepass 2018 PDF and VCE

In the exhibit, four routers (R1, R2, R3, and R4) are attached to a single Ethernet LAN and configured with addresses in the same subnet. All devices boot at the same time. Which router or routers will send a Network (Type 2) LSA for the network?

  1. R2

  2. R4

  3. R1 and R2

  4. R3 and R4

Answer: B

Question No: 216 – (Topic 3)

Which two statements describe nonstop routing? (Choose two.)

  1. RPD is running on the backup RE.

  2. Graceful restart is required for nonstop routing to function.

  3. Peer nodes are not alerted of RE mastership changes.

  4. COSD is running on the backup RE.

Answer: A,C

Question No: 217 – (Topic 3)

Which three types of firewall filters are supported by Juniper Networks EX Series Ethernet switches? (Choose three.)

  1. a VLAN-based firewall filter applied to Layer 3 in the ingress and egress directions

  2. a router-based firewall filter applied to Layer 2 routed interfaces in the ingress and egress directions

  3. a router-based firewall filter applied to Layer 3 routed interfaces in the ingress and egress directions

  4. a port-based firewall applied to Layer 2 switch ports in the ingress and egress direction

  5. a VLAN-based firewall applied to Layer 2 VLANs in the ingress and egress directions

Answer: C,D,E

Question No: 218 – (Topic 3)

Ensurepass 2018 PDF and VCE

In the configuration shown in the exhibit, you want to form an EBGP peering relationship to the loopback address of a router administered by your ISP, but the session will not establish. What is causing the problem?

  1. EBGP cannot peer to a virtual address.

  2. The EBGP session needs to be explicitly configured with multihop.

  3. The EBGP session needs to be explicitly configured as type external.

  4. The autonomous system information needs to be configured under [protocols bgp].

Answer: B

Question No: 219 – (Topic 3)

Ensurepass 2018 PDF and VCE

Refer to the router configuration shown in the exhibit. To which IS-IS area does this router belong?

  1. Area 49

  2. Area 0100

C. Area 49.2020

D. Area 49.2020.0100.1001.0001

Answer: C

Question No: 220 – (Topic 3)

Which three statements are true of GRE tunnels? (Choose three.)

  1. The local tunnel endpoint must have a valid route to the remote endpoint.

  2. GRE tunnels must authenticate at both ends of the tunnel.

  3. Tunnel endpoints must have a route that directs traffic into a tunnel.

  4. The quot;grquot; interface can only route packets that are IP protocol packets.

  5. All intermediary devices must have a route to the tunnel endpoints.

Answer: A,C,E

100% Ensurepass Free Download!
Download Free Demo:JN0-343 Demo PDF
100% Ensurepass Free Guaranteed!
JN0-343 Dumps

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

This entry was posted in JN0-343 Latest Exam (Jan 2018) and tagged , , , , , , , . Bookmark the permalink.

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.