[Free] New Updated (October) Avaya 3605 Real Exam Topic 1, Volume A part 05

Ensurepass

 

QUESTION 41  (Topic 1)

 

When multiple VLANs are used, Dynamic Host Control Protocol (DHCP) relay is required to get the DHCP information from the end user VLAN DHCP server.

 

Which statement about how to enable DHCP relay is true?

 

A.

The physical VLAN IP address is configured as the DHCP relay agent on each VLAN requiring a DHCP relay.

 

 

 

 

B.

The IP address of the DHCP server is configured as the relay agent globally on all switches that do not directly attach to the DHCP server.

C.

The MAC address of the DHCP server configured as the DHCP relay agent on each VLAN requiring the DHCP relay agent.

D.

The DHCP relay is configured globally and is automatically applied to all VLANs requiring a DHCP relay.

 

Answer: A

 

 

QUESTION 42  (Topic 1)

 

A split Multi-Link Trunking (SMLT) for switch clustering is being configured.

 

Which statement is a configuring requirement for the SMLT?

 

A.

CP-Limit is configured on edge switch stacks.

B.

Neighboring edge switch stacks should be connected to each other via a DMLT connection to add resilent paths in the event of an SMLT failure.

C.

Alternate the primary paths of the SMLT connection to load balance the switch core.

D.

VLANs that are defined on the SMLT are also defined on the MLT that defines the core inter Switch Trunks (IST).

 

Answer: D

 

 

QUESTION 43  (Topic 1)

 

Refer to the exhibit.

 

 

 

 

 

clip_image001[4]

 

A campus network has been established with four Ethernet Routing Switch (ERS) 8600 switches in a switch cluster, two pairs with an Inter Switch Trunks (IST) running Split Multi Link Trunk (SMLT) and Routed Split Multi-Link Trunking (RSMLT). The traffic filters are required to block specific source IP addresses to be forwarded through the core.

 

With reference to the exhibit, how should these filters be set up?

 

A.

Configure the filters on the 1ST first before any other ports.

B.

Apply the filters to all ports that receive traffic from outside the immediate switch cluster.

C.

Configure the filters on the ports first and then the IST.

D.

Configure and apply all the filters on the two core IST links only

 

Answer: B

 

 

QUESTION 44  (Topic 1)

 

Before enabling IP Source through Device Manager, which two conditions must be met on

 

 

 

 

the system?

 

A.

Dynamic Host Control Protocol (DHCP) snooping enabled globally.

B.

EAPOL must be enabled.

C.

The bsSourceGuardConfigMode MIB object must be removed.

D.

The port is an untrusted DHCP snooping and dynamic ARP Inspection port.

 

Answer: AD

 

 

QUESTION 45  (Topic 1)

 

Traceroute allows a route to be traced to a network using an Ethernet Routing Switch (ERS) 8600 CLI command. How could you use it to limit the number of hops the traceroute reports?

 

A.

Configure the (base UDP port) to the number of maximum number hops.

B.

Configure the (number of probes per TTL) to the number maximum number of hops.

C.

Configure the (maximum TTL value) to the number of maximum number of hops.

D.

Configure the (wait time per probe) to the number of maximum number of hops.

 

Answer: C

 

 

QUESTION 46  (Topic 1)

 

To confirm that routed split Multi-Link Trunking (RSMLT0 will work on a set of VLANs, which network design aspect should be considered?

 

A.

RSMLT is enabled on each SMLT VLAN on which the function is required.

B.

RSMLT is enabled on the VLAN group.

C.

Router 1 always owns the network.

D.

RSMLT is enabled on all SMLT VLANs.

 

Answer: A

 

 

QUESTION 47  (Topic 1)

 

You are configuring a QoS Policy on an ERS RS or 8800 module to police the ingress data

 

 

 

 

rate on a port with the following ACLI command on the interface level: qos if-policer police- rate 10000. What other two ACLI commands are required on the edge interface? (Choose two.)

 

A.

(config)#interface qos enable.

B.

(config-if)#enable-diffserv enable.

C.

(config-if)#access-diffserv enable.

D.

(config-if)#no core-diffserv enable.

 

Answer: BC

 

 

QUESTION 48  (Topic 1)

 

The attempt to manage an Ethernet Routing Switch (ERS) 8000 using a Virtual Route Redundancy Protocol (VRRP) address was not successful. What is causing this problem?

 

A.

The virtual router identifier is 0.

B.

The data center interface is set a
s a critical IP interface.

C.

A real IP address is required for management access not a VRRP address.

D.

The virtual router identifier is configured for the VRRP IP address owner.

 

Answer: C

 

 

QUESTION 49  (Topic 1)

 

For a Converged campus network, which configuration changes is recommended for the default VLAN (VLAN 1)

 

A.

Assign an IP address to the default VLAN for switch management.

B.

Remove all port members from default VLAN 1.

C.

Configure QoS on the default VLAN to support voice traffic.

D.

Remove spanning tree from the default VLAN.

 

Answer: A

 

 

QUESTION 50  (Topic 1)

 

 

 

 

An existing enterprise network is using Ethernet Routing Switch (ERS) 8600 switches in the campus core. It has been determined that 10 Gigabit links are required to replace the existing 1 gigabit uplinks will affect is connections on each of the ERS 8600 switches. Which statement describes how to accomplish this requirement in each ERS 8600 chassis?

 

A.

Replace the two existing switches fabric modules with 8394SF systems.

B.

Replace the two existing switch fabric modules with 8692SF and Supermez2

C.

Replace the two existing 8616SXE modules with 8612XLRS modules.

D.

Replace the six 8683XLK modules with 8612XLRS.

 

Answer: BC

Free VCE & PDF File for Avaya 3605 Real Exam

Instant Access to Free VCE Files: CompTIA | VMware | SAP …
Instant Access to Free PDF Files: CompTIA | VMware | SAP …

This entry was posted in 3605 Real Exam (October) and tagged , , , , , , . Bookmark the permalink.