[Free] New Updated (October) Avaya 3605 Real Exam Topic 2, Volume B part 04

Ensurepass

 

QUESTION 101  (Topic 2)

 

A technician is setting up switch clustering using Split Multi-Link Trunking (SMLT).

 

Which link is configured between the aggregation switches?

 

A.

Inter-switch trunk

B.

Multi-Link trunk

C.

Split MAC trunk

D.

LAG trunk

 

Answer: A

 

 

QUESTION 102  (Topic 2)

 

Which three functions describe VPFM? (Choose three.)

 

A.

It is a network health at a glance tool.

B.

It can correlate faults, traps, and provide notification.

C.

It is another term for the SNM credential.

D.

It is a baselining tool.

E.

It is a device configuration tool.

 

Answer: ABE

 

 

QUESTION 103  (Topic 2)

 

One of the benefits of the Ethernet Routing switch (ERS) 8300 switch is its ability to provide

 

 

 

 

power-over-Ethernet (PoE). When implementing PoE on the ERS 8300 there are certain power supply requirements to consider. The 8301AC produces 1140W and 1770W and the 8302AC produces 850W and 1400W depending on the input voltage for both cases.

 

If there are eight 8648TX-PWR modules in a chassis, each needing 200W for Powered Devices (PI)) which power supply configuration is recommended?

 

A.

One 8301AC power supply with 240VAC input voltage

B.

Two 8302AC power supplies with 120VAC input voltage

C.

Three 83CAC power supplies with 240VAC input voltage

D.

Two 8301AC and one 8302Ac for redundancy with 240VAC input voltage

 

Answer: C

 

 

QUESTION 104  (Topic 2)

 

A technician is configuring Multi Link trunking (SMLT) for an Ethernet routing switch (ERS) 8600 switch cluster. To ensure the fastest possible recovery time, which feature should be avoided?

 

A.

VLACP

B.

MLT

C.

802.3 ad

D.

SLPP

 

Answer: A

 

 

QUESTION 105  (Topic 2)

 

A technician has complied me configuration of an Ethernet Routing (ERS) 5520 to and now must transfer a backup copy of configuration file to server.

 

Which command is used to accomplish this task?

 

A.

5520.24T-PWR> copy config ftp filename ers5520 config.cfg

B.

5520-24T-PWR# copy config ftp filename ers5520config.cfg

C.

5570-74T PWR# copy config tftp filename ers5520COnfig.cfg

D.

5520-24T-PWR# copy config scp filename ersS520conftg.cfg

 

 

 

 

 

Answer: C

 

 

QUESTION 106  (Topic 2)

 

Which group of commands will configure Ethernet Routing Switch (ERS) 8600 to deny any source in the multicast group from reaching the multicast receivers connected to ERS 8600-B?

 

A.

config ip prefix-list “2” add-prefix 10.1.1.0/30 config vlan 2 ip igmp access-control 2 create 172.3.1.0 255.255.255.0 deny-tx

B.

config ip prefix-list “2” add-prefix 192.4.0-0/12 config vlan 2 ip igmp access-control 2 create 172.3.1.0 255.255.255.0 deny-rx

C.

config ip prefix-list “2” add-prefix 238.1.1.0/24 config vlan 2 ip igmp access-control 2 create 172.3.1.0 255.255.255.0 deny-tx

D.

config ip prefix-list “2” add-prefix 238.1.1.0/24 config vlan 2 ip igmp access-control 2 create 194.4.10.0 255.255.255.0 deny-tx

 

Answer: C

 

 

QUESTION 107  (Topic 2)

 

After issuing a show mlt list stats (CLI) or show ist Stat (ACLI) command, it is determined that the running type is normal MLT and not 1ST

 

What are two causes of the IST not running properly? (Choose two)

 

A.

The IST is not enabled on both switches.

B.

The MLT ID does not match on both switches.

C.

The peer IP address is not the address of the peer switch IST VLAN.

D.

The peer IP addresses have to be 192.168.1.1/30 and 192.168.1.2/30.

 

Answer: BC

 

 

QUESTION 108  (Topic 2)

 

A technician is adding the Virtual link Aggregation Control Protocol (VLACP) configuration to a Converged Campus Solution where
all Ethernet Routing Switches (ERSs) are directly connected without intermediary WAN transport devices.

 

 

 

 

What are two recommended configuration tasks? (Choose two.)

 

A.

Configure all links to use the same timeout value.

B.

For the Inter Switch Trunks (1ST) links, configure the long time-out value.

C.

For the SMLT links, configure the long timeout value.

D.

Configure all links to use a global reserved multicast MAC address for VLACP messages.

 

Answer: BD

 

 

QUESTION 109  (Topic 2)

 

A call centre is using the stacks of Ethernet Routing Switches (ERS) 5520-48T-PWR to supply power over Ethernet (PoE) to their IP telephones. Each switch is attached to 48 telephones. The call centre begins operation at 9:00 am each day and they verify that the switch can supply enough power to support each telephone drawing their maximum power for all switches simultaneously. They are using the IP Phone port 10/100 switch.

 

Which statement it is true if all telephones are drawing 13.2 watts simultaneously?

 

A.

Each switch of supplying full port to all ports with only the AC input

B.

Each switch requires an RPSU 15 in addition to AC to supply full power to all ports.

C.

RPSU 15 can support four ERS 5520 switches that supply full power to all ports.

D.

Each switch can supply full pow
er to all ports while the AC is unavailable if attached to

 

Answer: B

 

 

QUESTION 110  (Topic 2)

 

Ethernet Routing Switch (ERS) 5500 supports a resilient stacking architecture using FAST Stack technology with this stacking capability, what is the total stacking bandwidth for a full stack of eight switches?

 

A.

400 Gbps

B.

640 Gbps

C.

720 Gbps

D.

1.15 Tbps

 

Answer: B

 

Free VCE & PDF File for Avaya 3605 Real Exam

Instant Access to Free VCE Files: CompTIA | VMware | SAP …
Instant Access to Free PDF Files: CompTIA | VMware | SAP …

This entry was posted in 3605 Real Exam (October) and tagged , , , , , , . Bookmark the permalink.