[Free] New Updated (October) Juniper TK0-201 Real Exam 231-240

Ensurepass

 

QUESTION 231

Which three statements are correct about an AE interface? (Choose three.)

 

A.

It can be configured as either active or passive.

B.

It always load balances traffic equally.

C.

It can support LACP.

D.

It is referred to as a LAG.

E.

It can be configured as active only.

 

Correct Answer: ACD

 

 

QUESTION 232

You are configuring a firewall filter and need to select a terminating action. What are three terminating actions? (Choose three.)

 

A.

reject

B.

allow

C.

accept

D.

discard

E.

drop

 

Correct Answer: ACD

 

 

QUESTION 233

For two OSPF neighbors to establish a full adjacency on a broadcast medium, what information in their hello packets must match? (Choose two.)

 

A.

network mask

B.

router priority

C.

dead interval

D.

the list of neighbors on the network

 

Correct Answer: AC

 

 

QUESTION 234

A new BGP session has been configured. Upon monitoring the session state, you notice that the session has just transitioned from connect state to active state. What does the active state indicate for this BGP session?

 

A.

Something is wrong with your configuration. You must check your configuration and try again.

B.

This is the expected behavior. You should wait longer for the BGP session to establish.

C.

The OPEN messages collided. One BGP peer must be configured with the passive option.

D.

No route exists to the neighbors peering address. Check the IGP for reachability.

 

Correct Answer: B

 

 

QUESTION 235

In the exhibit, Areas 1.1.1.1 and 2.2.2.2 are configured as normal areas. In R7’s OSPF configuration, the interface on the 172.30.1.0/24 network is configured with the passive option. In which LSA type does R5 receive the announcement for the 172.30.1.0/24 network?

 

clip_image001

 

A.

Router (Type 1)

B.

Network (Type 2)

C.

Summary (Type 3)

D.

Extern (Type 5)

 

Correct Answer: C

QUESTION 236

You want to configure a tunnel between two routers, and run the IS-IS routing protocol through the tunnel. Which tunnel meets this requirement?

 

A.

GRE

B.

IP-IP

C.

IPsec

D.

NGMVPN

 

Correct Answer: A

 

 

QUESTION 237

Which Junos platform provides Ethernet switching services?

 

A.

M Series

B.

T Series

C.

EX Series

D.

MAG Series

 

Correct Answer: C

 

 

QUESTION 238

What is a difference between a generated route and an aggregated route?

 

A.

Generated routes have a higher preference by default.

B.

Generated routes use a next hop of discard.

C.

Generated routes have a lower preference by default.

D.

Generated routes use a next hop of a contributing route.

 

Correct Answer: D

 

 

QUESTION 239

A GRE tunnel is established between two routers. When a user on one end sends traffic with a large packet size to a user on the remote end, the packet never arrives. However, the problem does not exist for smaller packets. What is the problem?

 

A.

The tunnel is down on the remote end.

B.

The don’t-fragment bit is set on the traffic.

C.

GRE tunnels do not support IP traffic.

D.

No dynamic routing protocol exists to handle the traffic.

 

Correct Answer: B

 

 

 

 

 

 

 

 

QUESTION 240

Which statement is correct regarding the VLAN factory-default configuration on an EX Series switch?

 

A.

The default configuration assigns the default VLAN to use ID 0.

B.

The default configuration assigns the default VLAN to use ID 10.

C.

The default configuration assigns all switch ports to the default VLAN.

D.

The default configuration assigns the management port only to the default VLAN.

 

Correct Answer: C

Free VCE & PDF File for Juniper TK0-201 Real Exam

Instant Access to Free VCE Files: Juniper | Juniper | SAP …
Instant Access to Free PDF Files: Juniper | Juniper | SAP …

This entry was posted in TK0-201 Real Exam (October) and tagged , , , , , , . Bookmark the permalink.